Cirque Ceiling Fan

Enjoy art… the Cirque ceiling fan, a high performance dynamic sculpture, GOOD DESIGN Award winner. It has very good air-moving performance due to an innovative upsweep of the small blades and a generous pitch of the large blades which coupled with a halogen downlight provide high comfort and low energy consumption. Design: Mark Gajewski, G Squared

click here for specifications

printable PDF cut sheet

Step 1 Select the finish

Please choose the finish of the fan. The blades as shown in the pictures below are always included in a sealed box with the fan. You will get a chance to add optional blades in Step 4 below.

Cirque Ceiling Fan
F596-BN
Brushed nickel with silver blades

$349.95 add to cart

Step 2 Select the downrod length based on your ceiling height

Cirque Ceiling Fan optional downrod photo

This fan is OK for standard 8 foot ceilings. Optional downrods are available for high ceilings. To calculate the distance from the ceiling to the bottom of the blades, add the length of the downrod to the dimension on the right of the diagram. For safe blade height subtract this distance from the height of your ceiling at the point where the fan will be mounted and make sure that it is at least 84 inches (7 feet).

Optional Downrods

Step 3 Select optional accessories

The hand held remote will operate the fan independently of the wall switch: if you choose it the wall switch will not have to be installed. If your ceiling slope is greater than 30 degrees but less than 45 degrees you will need the slope adapter to install the fan.

Hand held remote
RC210 White

$36.00 add to cart

Sloped ceiling adapter
A145

$25.00 add to cart

Step 4 Select optional fan blades if desired

The optional blades are made specifically for this fan model. They are shipped in addition to the blades provided with the fan.

Mahogany
FB196-MG

$36.00 add to cart

Multicolored:red, yellow, blue
FB196-RYB

$36.00 add to cart

Specifications and What Comes Standard with this Fan

printable PDF cut sheet

54" diameter major blades and 25” diameter minor blades
3 speeds; reversible
Integrated 50 watt MR16 halogen bulb
Lifetime warranty on motor, 1 year on rest of fan
Sloped ceilings OK up to 29 degrees without adapter
Sloped ceilings up to 45 degrees OK with accessory adapter available at additional cost

Models available:
F596-BN - brushed nickel with silver blades

Controls:
Wall mount touch control included – controls 3 speeds, reverse, plus infinite dimmer for light; fits in Decora sized wall plate
Hand held remote available at additional cost – can be used along with wall switch or alone (without need to install wall switch)
Both wall mount and hand held controls work by sending RF signals to receiver in fan – no need for third wire when wiring for fan

Optional blades:
Fan comes with blade finish as shown; optional blades available at additional cost include multicolored (red, yellow, blue) and mahogany

Downrods:
Fan comes standard with 3 ½” and 6” downrods – length to bottom of fan is 14 ½” with 3 ½” downrod and 17” with 6” downrod (good for 8 foot ceilings)
Longer accessory downrods are available at additional cost in 12”, 18”, 24”, 36”, 48”, 60”, and 72” lengths
Downrods cannot be added together or cut to fit
Sloped ceiling adapter kit is available for ceilings with slopes between 30 and 45 degrees at additional cost